产品规格：
产品数量：
包装说明：
关 键 词：atmel,studio7安装问题
行 业：电子 电子产品设计
发布时间：2022-12-01
ATtiny88 Automotive 8-bit AVR Microcontroller with 8K Bytes In-System Programmable Flash DATASHEET Features High performance, low power AVR 8-Bit microcontroller Advanced RISC architecture 123 powerful instructions most single clock cycle e...
ThePC7 and PC[5:0] output buffers have symmetrical drive characteristics with both sink and sourcecapability. As inputs, Port C pins that are externally pulled low will source current if the pull-upresistors are activated. The Port C pins are tri-stated when a reset condition becomes active,even if the clock is not running.1.1.7PC6/RESETIf the RSTDISBL Fuse is programmed,
1.1Pin Descriptions1.1.1VCCDigital supply voltage.1.1.2AVCCAVCC is the supply voltage pin for the A/D converter and a selection of I/O pins. This pin shouldbe externally connected to VCC even if the ADC is not used. If the ADC is used, it is recom-mended this pin is connected to VCC through a low-pass filter, as described in “Analog NoiseCanceling Techniques” on page 172.The following pins receive their supply voltage from AVCC: PC7, PC[5:0] and (in 32-lead pack-ages) PA[1:0].
I/O and Packages– 24 Programmable I/O Lines:• 28-pin PDIP• 28-pad QFN– 28 Programmable I/O Lines:• 32-lead TQFP• 32-pad QFN• 32-ball UFBGA•Operating Voltage:–1.8–5.5V•Temperature Range:–-40°C to +85°C•Speed Grade:–0–4 MHz @ 1.8 – 5.5V–0 – 8 MHz @ 2.7 – 5.5V–0 – 12 MHz @ 4.5 – 5.5V•Low Power Consumption– Active Mode: 1 MHz, 1.8V: 240 μA– Power-Down Mode: 0.1 μA at 1.8V
The Port B pins are tri-stated when a reset condition becomes active, even if the clockis not running.Depending on the clock selection fuse settings, PB6 can be used as input to the internal clockoperating circuit.The various special features of Port B are elaborated in “Alternate Functions of Port B” on page69.1.1.6Port C (PC7, PC5:0)Port C is a 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit).
The ATtiny48/88 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISCarchitecture. By executing powerful instructions in a single clock cycle, the ATtiny48/88 achievesthroughputs approaching 1 MIPS per MHz allowing the system designer to optimize power con-sumption versus processing speed.
