Oxygen compressor Connecting Rod wenzhou
价格：777.00起
产品规格：
产品数量：
包装说明：
关 键 词：compressor,Oxygen
行 业：机械 泵 往复泵
发布时间：2021-08-02
Basics, Compressor
Compressor Basics Components, Reciprocating Compressor, Reciprocating
Compressor Basics, Reciprocating Compressor Basics Components
The packing rings are the important element of rod packing assembly. The below-listed
packing rings are widely used in a reciprocating compressor.
The Figure shows a drilled crankshaft.
Crankshafts should have removable balance weights to compensate the rotary unbalance
as well as reciprocating unbalances. The crankshaft should be dynamically balanced
when above 800 rpm.
The crosshead pin should have a replaceable bush bearing.
Connecting Rod连杆
Purpose of the connecting rod is to connect the crankshaft and the crosshead. The
connecting rod converts the rotary motion into reciprocating motion. The connecting
rod bolts and nuts shall be securely locked with cotter pins or wire after assembly.
Like Crankshafts, the connecting rod has drilled hole for oil passage.
For the larger capacity compressor, cylinders are provided with replaceable linear.
In smaller capacity compressors, particularly for single stage models the replaceable liner is not economical and may not be available.
The cylinders are equipped for the cooling arrangement to reduce the temperature rise during the compression cycle. This is usually by means of a water jacket if water jacketing in the cylinder is not feasible than fins are provided in the cylinder for air cooling. The latter method is limited to either small or special purpose machines.
