FSL6二手R&S罗德与施瓦茨频谱分析仪出售
价格：面议
FSQ26 20Hz至26.5GHz。
FSQ不仅继承了FSU的出色的频谱分析仪特性和功能，而且其解调和分析带宽可高达120MHz，还提供了基站频谱杂散发射和多载波测量所必需的高动态范围。因此，FSQ是进行下列产品开发和生产的理想工具：WLAN、WiMAX、WCDMA、HSPA/HSPA+、GSM/EDGE/GPRS、CDMA2000/1x EV-DO、TD-SCDMA、LTE TDD/LTE FDD、Bluetooth等。
为了解决日益增加的数据吞吐量问题，未来移动无线和相关领域对带宽的要求必然越来越高。即使今天，GSM或3GPP基站的多载波信号在功率输出阶段常常需要进行放大，尽管这样一方面可以降低技术要求和成本，但同时也增加了传输带宽。随着分析带宽要求的提高，现有频谱分析仪产品已经难于满足分析要求，市场需要具有更高分析带宽的产品，而同时满足动态范围的苛刻要求。
R&S?FSQ不仅继承了R&S?FSU的出色的频谱分析仪特性和功能，而且其解调和分析带宽可高达120MHz。因此，R&S?FSQ是进行下列产品开发和生产的理想工具：
?WLAN
?3GPP和 GSM-MCPA
?WiMAX
除此之外，当与下列应用选件一起工作时，R&S? FSQ26还能支持2G、2.5G、3G以及4G移动无线系统的测量应用：
GSM/EDGE Application Firmware
R&S?FS-K5
AM/FM/PM Measurement Demodulator
for R&S?FSQ/FSU/FSP/FSUP Analyzers and the R&S?ESCI/ESPI Test Receivers
R&S?FS-K7
Bluetooth? Application Firmware
R&S?FS-K8
Power Sensor Measurements
R&S?FS-K9
GSM/EDGE/EDGE Evolution Measurements
R&S?FS-K10
VOR/ILS Measurement Demodulator
for R&S?FSMR/R&S?FSU/R&S?FSQ - Analysis for VOR and ILS signals
R&S?FS-K15
Application Firmware for Noise Figure and Gain Measurements for R&S?FSP, R&S?FSU and R&S?FSQ (preamplifier recommended, e.g. R&S?FSU-B25)
Outperforming any conventional noise measurement system
R&S?FS-K30
Application Firmware for phase noise measurements
R&S?FS-K40
Firmware General Purpose Vector Signal Analyzer
Universal demodulation, analysis and documentation of digital radio signals
This option is available for instruments for:
R&S?FSUP8: as of serial number 100024
R&S?FSUP26: as of serial number 100068
R&S?FSUP50: as of serial number 100013
R&S?FSQ-K70
3GPP BTS/Node B FDD Application Firmware
3GPP transmitter measurements with R&S?FSQ signal analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers
R&S?FS-K72
3GPP UE FDD Application Firmware (including HSUPA)
3GPP transmitter measurements with R&S?FSQ signal analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers
R&S?FS-K73
3GPP HSPA+ UE Application Firmware
3GPP transmitter measurements with R&S?FSQ signal analyzers and R&S?FSU, R&S?FSG and R&S?FSP spectrum analyzers.
Requires R&S?FS-K73
R&S?FS-K73+
3GPP HSDPA Base Transceiver Station (BTS) Application Firmware
3GPP transmitter measurements with R&S?FSQ signal analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers.
Requires R&S?FS-K72
R&S?FS-K74
3GPP HSPA+ BTS Application Firmware
3GPP transmitter measurements with R&S?FSQ signal analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers.
Requires R&S?FS-K74
R&S?FS-K74+
3GPP TD-SCDMA BTS Application Firmware
Base station and mobile station tests on TD-SCDMA with the R&S?FSQ, R&S?FSU and R&S?FSP
R&S?FS-K76
3GPP TD-SCDMA Mobile Station (MS) Application Firmware
Base station and mobile station tests on TD-SCDMA with the R&S?FSQ, R&S?FSU and R&S?FSP
R&S?FS-K77
CDMA2000? / IS-95 (cdmaOne) / 1xEV-DV BTS Test Application Firmware
R&S?FS-K82
CDMA2000? /1xEV-DV MS Application Firmware
R&S?FS-K83
CDMA2000? 1xEV-DO Base Station Test Application Firmware (including Rev A)
Transmitter measurement on 3GPP2 signals with Signal Analyzer R&S?FSQ and Spectrum Analyzers R&S?FSU and R&S?FSP
R&S?FS-K84
CDMA2000? 1xEV-DO Mobile Station Test Application Firmware
Transmitter measurement on 3GPP2 signals with Signal Analyzer R&S?FSQ and Spectrum Analyzers R&S?FSU and R&S?FSP
R&S?FS-K85
WLAN 802.11a/b/g/j Application Firmware
R&S?FSQ-K90
WLAN Application Firmware
WLAN IEEE 802.11 a/b/g/j TX Application Firmware
R&S?FSQ-K91
WLAN Application Firmware
R&S?FSQ-K91 Upgrade to IEEE 802.11n
R&S?FSQ-K91n
Application Firmware
TX measurements on OFDM signals in line with IEEE 802.16-2004
R&S?FSQ-K92
Application Firmware
R&S?FSQ-K92 to R&S?FSQ-K93 Upgrade
(R&S?FSQ-K92 required)
R&S?FSQ-K92U
Application Firmware
TX measurements on OFDMA signals in line with IEEE 802.16-2004, IEEE 802.16e-2005
R&S?FSQ-K93
Application Firmware
TX measurements on WiMAXTM MIMO signals in line with IEEE 802.16e-2005
R&S?FSQ-K94
Analysis of EUTRA/LTE FDD downlink signals
3GPP LTE transmitter measurements on base stations and modules with the R&S?FSG and R&S?FSQ Signal Analyzer
R&S?FSQ-K100
Analysis of EUTRA/LTE FDD uplink signals
3GPP LTE transmitter measurements on user equipment and modules with the R&S?FSG and R&S?FSQ Signal Analyzer
R&S?FSQ-K101
Analysis of EUTRA/LTE downlink MIMO signals
3GPP LTE transmitter measurements on base stations and modules with the R&S?FSG and R&S?FSQ Signal Analyzer
(requires R&S?FSQ-K100)
R&S?FSQ-K102
Analysis of EUTRA/LTE TDD downlink signals
Transmitter measurements on LTE signals
R&S?FSQ-K104
Analysis of EUTRA/LTE TDD uplink signals
Transmitter measurements on LTE signals
R&S?FSQ-K105
TETRA Release 2 Analysis
TETRA/TEDS measurements for the R&S?FSU / R&S?FSQ
R&S?FS-K110
R&S FSP13_罗德与施瓦茨频谱仪13.6G频谱仪
全新的FSP产品系列将高端分析仪FSE和FSIQ的众所周知的优点系统地集成到中级分析仪中。
FSP树立了中端产品测量速度和精确度的标准，它采用了高度集成的前端和全数字信号处理的后端,并与R&S的先进ASIC相结合,是具有指标和高可靠性的产品.
FSP13系列频率范围：
FSP3：9KHz - 3GHz
FSP7：9KHz - 7GHz
FSP13：9KHz - 13.6GHz
FSP30：9KHz - 30GHz
FSP40：9KHz - 40GHz
分辨率带宽：1 Hz 到10 MHz
显示平均本地噪声：-155 dBm
相位噪声：-113 dBc (1 Hz) 在10 kHz偏移处
性能：
提供全方位的检波器选择：Max, Min-, Auto-Peak, Sample, RMS, Average, Quasi-Peak
信道/邻信道/快速邻信道功率测量：预置各种通讯标准
多载波邻信道功率测量：可以独立的设置载波间隔
邻信道/多载波邻信道功率测量：可以测量12个邻信道
支持三阶互调截断点（(TOI)、占用带宽(OBW)、相位噪声、邻信道功率（ACPR）、AM调制深度测量
谐波失真测量
支持互补累积分布函数（CCDF）和幅度概率分布函数（APD）测量
可编辑的限制线，并支持PASS/FAIL指示
订购信息：
FS-K4 相位噪声测量
FS-K5 GSM/EDGE基站和移动台信号的调制和频谱测量
FS-K7 通用的AM/FM/jM解调测量
FS-K8 蓝牙发射测量
FS-K9 功率探头测量
FS-K74 根据3GPP TS24.141标准对基站信号(NodeB)进行调制和码域功能测量
FS-K73 根据3GPP TS25.141标准对移动台信号(UE)进行调制和码域功能测量
FS-K76 TD-SCDMA基站信号的调制和码域功能测量
FS-K76 TD-SCDMA移动台信号(UE)的调制和码域功能测量
FS-K82 根据cdma2000/1xEV-DV标准对基站信号进行调制和码域功能测量
FS-K83 对cdma2000/1xEV-DV移动台信号(UE)的调制和码域功能测量
FS-K84 对1xEV-DO基站信号进行调制和码域功能测量
FS-K85 对1xEV-DO移动台信号(UE)进行调制和码域功能测量
FS-K30 噪声系数测量（应用固件）
产品型号：FSU8
产品品牌：R&S 罗德与施瓦茨
产品名称：频谱分析仪
FSU8|R&S|8G|频谱分析仪|罗德与施瓦茨|20Hz至8GHz
FSU8详细说明：
R&S 罗德与施瓦茨FSU 系列频谱分析仪
FSU3 20 Hz to3.6 GHz
FSU8 20 Hz to 8GHz
FSU26 20 Hz to26.5 GHz
FSU46 20 Hz to46 GHz
FSU50 20 Hz to50 GHz
FSU67 20 Hz to67GHz
R&S FSU8系列频谱仪是动态范围、相位噪声、电平精度和分辨率带宽等频谱仪指标的领导者，所有这些指标也是用户设计、测量和生产下一代无线通讯元件的重要保障。
FSU8频率范围：从20Hz开始，分别到3.6 GHz, 8 GHz, 26.5 GHz, 46 GHz和50 GHz
FSU8显示平均本地噪声：-158 dBm(归一化到1 Hz)
FSU8相位噪声：-123 dBc (1 Hz) 在10 kHz偏移处
FSU8三阶互调截断点（TOI）：典型值+25 dBm
FSU8分辨率带宽：1 Hz 到50 MHz
FSU8极高的测量速度支持时域模式的快速邻信道功率（ACP）测量每秒能进行70次测量（包括通过GPIB总线传输数据的时间）
无可匹敌的测量功能标准配置即可提供TOI, MC ACP(R), OBW,CCDF, APD等测量功能选件可以支持：- GSM / EDGE -Bluetooth? - WCDMA / HSDPA / TD-SCDMA - CDMA2000? / 1xEV-DV /1xEV-DO
-/gjhied/-
