价格：153起
上海环央化工科技有限公司
联系人：梅经理
电话：18717948525
地址：上海市闵行区浦江镇三鲁公路2755号
产品规格：
产品数量：0 个
包装说明：桶装
关 键 词：德国汉高乐泰FrekotePMC,汉高汉高乐泰FrekotePMC,汉高乐泰FrekotePMC,FrekotePMC,FrekotePMC聚酯脱模剂
发布时间：2023-03-21
LOCTITE® Frekote PMC™ is a special blend of solvents designed to dissolve and remove wax from polyester molds without dulling the surface. This product can also be used to clean epoxy and metal mold surfaces as well as for cleaning bes and equipment. LOCTITE® Frekote PMC™ is highly recommended for preparing polyester mold surfaces prior to application of Frekote® mold sealers and mold release agents. TYPICAL PROPERTIES OF UNCURED MATERIAL Specific Gravity @ 25 °C 0.821 to 0.854LMS Flash Point - See SDS GENERAL INFORMATION This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials. For safe handling information on this product, consult the Safety Data Sheet (SDS). Directions for use 1. LOCTITE® Frekote PMC™ should be applied to the mold surface with a clean lint free cloth. 2. Wax and other mold residue will immediately begin to dissolve and should be removed from the surface with a second clean cloth while it is still dissolved in the LOCTITE® Frekote PMC™. 3. As the cloth becomes saturated with wax and mold residue, dispose of it and use a new cloth. 4. Repeat process until composite and other mold residue is removed. 5. The mold is now ready for use. 6. NOTE: A simple test to assess mold cleanliness is the use of masking tape. A coated surface will allow easy release of masking tape, where as a wax free surface will allow good adhesion of masking tape. This test can also be used to determine the effectiveness of Frekote® Release Interfaces. A good interface will prevent any significant degree of tape adhesion